Every charge point in one interface, whatever the make.
Every make comes with a portal of its own, and at month end the figures are added up by hand. CPIM lays one interface over all of it, records every charging session, and starts at 13 € a month.
What happens between the station and the invoice.
The station registers itself, CPIM records every charging session, and the report is ready at month end.
Every make, one interface
Charge points speak an open standard. Which make hangs on the wall stays your decision.
Read more →The state of every station, live
Who is charging, who is free, who is idle. The overview keeps itself up to date.
Read more →Billing without the arithmetic
Every charging session carries its meter reading and its price. The export goes straight to your accounts.
Read more →Release and block charging cards
A card works on the charge groups you assign it to. A lost card is blocked in seconds.
Read more →A standstill shows up at once
When a station stops sending its heartbeat, CPIM raises an alarm after two hours.
Read more →Data stays in Germany
Operated on servers in Germany and developed in Germany. No transfer abroad.
Read more →
This is CPIM in daily use.
A tour through the interface, with example data from the test system.
Where this pays off.
Three starting points, the same application.
From the station to the first invoice.
Three steps, in this order.
- 01
Connect the station
Enter the CPIM address in the charging station. The station registers itself and appears in the overview a few seconds later.
- 02
Set cards and price
Each company sets its own price per kilowatt hour. Which card may charge on which charge group is decided in one place.
- 03
Bill and review
At month end every charging session sits in the report with its meter reading and its price. The export is an Excel file.
A portal per make, or one interface for all of them.
On the left the situation most operators are in. On the right what changes.
A portal per make
One interface for all
Pilot customers are joining now.
CPIM is new and under active development. The application runs, tested against real hardware.
What you get
- Your own installation with your charge points.
- Terms agreed directly, for as long as the pilot programme runs.
- A direct line to development, without a ticket system.
- A say in which function gets built next.
What we need in return
- One charging station that is allowed to connect to CPIM.
- The make, the firmware and the OCPP release of that station.
- A report on what works and what does not. “It works” counts too.
Let us talk about your charge points.
Tell us which stations you have on site. A person answers, usually on the next working day.
Prefer it direct? info@dstech-it.de